| Bulletin Number | Vehicle Make | Vehicle Model | Model Year | Summary |
|---|---|---|---|---|
| SP19-301 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, the compressor & radiator door lower hinges must be replaced by new stainless steel units<br /> |
| IS-19922 | PREVOST | X3 | 2016 | PREVOST AWARE ADAPTIVE CRUISE BRAKING (ACB) FLR10 TO FLR21 RADAR SENSOR UPGRADE<br /> |
| SP18-307 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, the Bitzer compressor shaft seal must be replaced. Additionally, the compressor oil must be renewed and the |
| WB16-02H | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, it is necessary to perform a Multiplex software update plus other corrective measures to improve the chargi |
| SP17-314-R13 | PREVOST | X3 | 2016 | This bulletin explains how to install a light at the entrance door.<br /> |
| Sp18-304A | PREVOST | X3 | 2016 | For vehicles affected by this bulletin, on the wheelchair area sliding door, install a new upper roller carrier, adjust the door and inspect all faste |
| Sp18-303 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, the condenser compartment wall may present fatigue cracks on or near the A/C receiver tank support. Follow |
| Sp18-301 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, the existing surge tank support has to be replaced by a new configuration including two supports. That will |
| Sp18-302 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, install a pressure switch into the front service compartment to send a faster signal to the Allison transmi |
| SP17-314 | PREVOST | X3 | 2016 | This bulletin explains how to install a light at the entrance door.<br /> |
| SP17-314 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, install a light at the entrance door.<br /> |
| SP17-313 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace the batteries by a new set (4) of the same model; perform several verifications on the alternator a |
| Sp18-300 | PREVOST | X3 | 2016 | This bulletin explains how to replace ceiling transition pannels, when needed<br /> |
| SP16-304 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace the battery connection decal by a new version.<br /> |
| MI16-07 | PREVOST | X3 | 2016 | Prevost is now offering a clutch replacement kit for vehicles equipped with a Kendrion (Linnig) LLW203 Series fan clutch and gearbox assembly. This k |
| Sp16-323 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, change a parameter in the MUX system to deactivate a DTC corresponding to air dryer cartridge change warnin |
| Mi16-15 | PREVOST | X3 | 2016 | The Beru sensors used on Prevost vehicles to monitor tire pressure (TPMS system) are being replaced by new Huf sensors and their corresponding stainle |
| SP17-307 | PREVOST | X3 | 2016 | This bulletin explains how to replace the Radiator Door Upper Hinge<br /> |
| SP17-303D | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace two idlers by an improved version on the alternator drive belt and on the A/C belts.<br /> |
| WB16-02 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, it is necessary to perform a Multiplex software update plus other corrective measures to improve the chargi |
| SP16-306A | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace an access panel aft of the tag axle wheel, road side.<br /> |
| Sp16-302A | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace the pressure cap on the surge tank.<br /> |
| Sp16-313A | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, coolant may leak by the coolant level sensor wires on the surge tank. Replace the sensor with an improved v |
| Sp16-311A | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, add two clips to secure the direct light lenses, 13 lenses per vehicle.<br /> |
| Sp16-26 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, an additional decal should be affixed to the engine compartment. Perform the addition to comply with Title |
| Sp16-303B | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, reposition the harness out of the path of an unlocked electrical box door.<br /> |
| SP16-306 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace an access panel aft of the tag axle wheel, road side.<br /> |
| WB16-02B | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, it is necessary to perform a Multiplex software update plus other corrective measures to improve the chargi |
| Sp16-309A | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, secure the mounting of the curb side engine door electrical fan.<br /> |
| Sp16-303C | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, reposition the harness out of the path of an unlocked electrical box door.<br /> |
| Sp16-300C | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, improvement of a Charge Air Cooler tube support is required.<br /> |
| Sp16-317 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, it is necessary to ensure proper brake pedal installation and adjustment following the procedure below.<br |
| IS-16902 | PREVOST | X3 | 2016 | This instruction sheet explains how to install and adjust Brake Pedal kit IS16902<br /> |
| Wb17-14A | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, the power cable stud adapter on the alternator must be inspected and if needed, replaced.<br /> |
| sp17-310 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, it is necessary to replace the two engine door latch pins and the compressor door latch pin by new units ma |
| Sp17-312 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, bus washing operations can result in water dripping into the front service compartment. Add a drip guard ab |
| Sp17-311 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace connector C12 installed inside the DPF access door with an improved version providing a better seal |
| SP16-326 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, re-torque the clamps on specific coolant hoses of the cooling system.<br /> |
| SP16-311B | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, add two clips to secure the direct light lenses, 13 lenses per vehicle.<br /> |
| SP15-341C | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace the horn support by 140034.<br /> |
| SP16-311G | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, add Z clips to secure the direct light lenses, 13 lenses per vehicle.<br /> |
| Sp16-309 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, secure the mounting of the curb side engine door electrical fan.<br /> |
| SP16-300B | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, improvement of a Charge Air Cooler tube support is required.<br /> |
| MI16-12 | PREVOST | X3 | 2016 | This Maintenance Information explains how to perform the replacement of glued fixed thermos window. This procedure may also be used for the replaceme |
| SP16-303 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, reposition the harness out of the path of an unlocked electrical box door.<br /> |
| WB15-55 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, inspect the gap between the radius rod support and the front axle. A deviation in the axle beam envelope ca |
| SP16-302 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace the pressure cap on the surge tank.<br /> |
| WB16-04 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin the steering damping cylinder rod end spherical bearing may be loose in its housing. Replace as required and |
| Sp17-313 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace the batteries by a new set (4) of the same model; perform several verifications on the alternator a |
| WB16-02C | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, it is necessary to perform a Multiplex software update plus other corrective measures to improve the chargi |
| Sp16-320 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, the compressor door support to the vehicle must be improved by the addition of a lower support bracket and |
| WB16-02E | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, it is necessary to perform a Multiplex software update plus other corrective measures to improve the chargi |
| Sp16-326B | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, re-torque the clamps on specific coolant hoses of the cooling system.<br /> |
| WB17-06 | PREVOST | X3 | 2016 | On the vehicles affected by this bulletin, replace the existing wheelchair lift control pendant support by an improved version.<br /> |
Subscribe for our latest newslatters
Know if there is a safety problem with your vehicles, tires or car seat, and how to get it fixed.